8/2/2023 0 Comments Cetus3d user manual![]() As such, additional exposure to light may be necessary. When you take your watch off, be sure to place it in as bright an area as possible. Notes on rechargingĪvoid recharging your watch in areas of high temperatures (over about 60 ☌ / 140 ☏), otherwise the sensitive components of the watch may become damaged. ![]() (e.g.) Incandescent lights generate heat sufficient to damage your watch. Be sure to keep the watch at least 50cm (20inches) away from the bulb so no damage occurs. We do not recommend the use of Halogen bulbs for recharging. ![]() Never place your watch on the dashboard or rear deck of a vehicle as the heat generated in these areas can damage your watch. Unlike ordinary watches, the special rechargeable cell used in your watch does not need regular replacement. This is a clean energy cell that will last the life of the watch. The energy cell should last the life of the watch. Never allow anyone other than an Authorized Service Center to replace this cell. The movement is designed to operate with only the original rechargeable cell. If an alternate cell is installed, such as a conventional battery, the battery may become overcharged resulting in damage to the movement and/or bursting of the cell, which could cause injury to the user. TIME REQUIRED FOR CHARGINGīelow are the approximate times required for charging when exposing the watch dial to light continuously. This table is for general reference only and does not represent exact charging times. Illuminance (lx) Charging time (approx.) To work for one day To start working normally when the cell is discharged To become fully charged when the cell is discharged Outdoors (sunny) 100,000 2 minutes 17 minutes 11 hours Outdoors (cloudy) 10,000 11 minutes 2 hours 35 hours 20 cm (7-7/8 inches) from a fluorescent lamp (30W) 3,000 40 minutes 7 hours 120 hours Interior lighting 500 4 hours 50 hours. To become fully charged when the cell is discharged… The recharging time is the time the watch is continuously exposed to direct light. Time required to fully charge when the watch has completely stopped. Time required to charge the watch sufficient for one-day use with one second interval operation. When recharging the watch after it is completely in the stop state, be sure to pull out the crown to the time setting position.Īfter recharging, set the time and push the crown firmly back into its normal position. The second hand starts moving at two second intervals in order to warn that the watch will stop functioning after about 1 week. (Insufficient Charge Warning Function) In such a case, expose your watch to light for a while to cancel the warning.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |